GNBApr 30, Cut the subwoofer frame. Then I stubled across these pull cables for recliners. I've see some other cable solutions for people with platform installs, but nothing that looked this factory. ColoDisco said:. Fix actuator clip with zipties. He was not happy to find out that the only solution involved a hole saw and a couple hours labor. Perhaps "remove" is too strong a word, but you do not need a hole saw, or any drilling or cutting anything to get your door open.
I am sure I can make a plan, if I can get the tailgate open (top).
Is there a Land Rover Discovery 2 TD5 GS - Yes, had two of them. I have a Disco 4 and the tailgate won't open when the top release button is pushed. assume ur not complaining about not being able to open the boot with searching for solutions to this particular problem on Discovery 4's.
Tailgate not opening on discovery 3 LandyZone Land Rover Forum
One morning she woke up to find her boot open over night. can be over- sensitive and open/close when not intended and when someone or.
Here is the process to get it installed. I agree it's a bit complex but as you said, it ends up looking factory and should work excellent.
I just epoxied a L shape bracket to the plastic housing carefully 9 years a go and so far no breakage yet. I then removed the carpet and made sure that this center point would not interfere with the actual sub or any of the mounting bolts for the subwoofer.
In order to mount it into the actuator assembly, I found that the cable clip aligned very well with one of the existing screw positions.
boot release Discovery Sport Forums
I looked up this.
Same to me, tailgate door will not open, can hear noise but no one home I also have a . Simpler to do as only intermittent fault and managed to open boot and. The manual also suggest an emergency procedure to open the tailgate by Discovery II. Disco3 Tailgate not opening cheap repair.
The solution is very simple.
Use a dremel to cut a hole in the carpet section of the tail gate using the center point we drilled earlier. You must log in or register to reply here. This is the latest actuator. I searched forever to find something just right. I also added a zip tie around the end of the pull cable to make sure it was permanently secured into my makeshift sheetmetal bracket.
LR3/LR4 REQUIRED UPGRADE Prevent Rear Door Failure for $25 Expedition Portal
You will need to remove some extra plastic material at the N S E W positions to make clearance for the metal tabs.